FUJITSU LIFEBOOK 990TX2 - Manual (Page 176)

S e c t i o n F i v e
166
POWER ON SELF TEST MESSAGES
The following is an alphabetic list of error-and-
status messages which Phoenix BIOS and/or
your operating system can generate and an
explanation of each message.Error messages
are marked with an *. Comments in italics
are suggestions of possible actions for you to
consider or risks resulting from ignoring the
message. The most common errors are marked
with a #. If an error message is displayed that is
not in this list, write it down and check your
operating system documentation both on
screen and in the manual. If you can find no
reference to the message and its meaning is not
clear, contact your support representative
for assistance.
nnnn Cache SRAM Passed – Where nnnn
is the amount of system cache in kilobytes
successfully tested by the Power On Self Test
(POST). (This can only appear if you have an
SRAM PC Card installed.)
*Diskette drive A error or Diskette drive B
error – Drive A: or B:is present but fails the
BIOS Power On Self Test (POST) diskette tests.
Check to see that the drive is defined with the
proper diskette type in the Utility Setup, (see page
59,) and that the diskette drive is installed cor-
rectly, (see pages 121 and 122). If the disk drive is
properly defined and installed avoid using it and
contact your support representative.
*Extended RAM Failed at offset:nnnn –
Extended memory not working or not config-
ured properly. If you have an installed a memor y
upgrade module verify that the module is proper-
ly installed. If it is properly installed you may
want to check your Windows Setup so it is not
trying to use unavailable memory until you can
contact your support representative.
nnnn Extended RAM Passed – Where nnnn
is the amount of memory in kilobytes
successfully tested.
*Failing Bits:nnnn – The hex number nnnn
is a map of the bits at the memory address
(in System, Extended, or Shadow memory)
which failed the memory test. Each 1 (one) in
the map indicates a failed bit. This is a serious
fault which might cause you to lose data if you
continue. Contact your support representative.
*Fixed Disk x Failure or Fixed Disk Controller
Failure (where x = 1-4) – Fixed disk is not
working or not configured properly. This may
mean that the hard drive type identified in your
Setup Utility does not agree with the type
detected by the Power On Self Test (POST).
Run the Setup Utility to check for the hard disk
type settings and correct them if necessary. If the
settings are OK and the message appears when
you restart the system there may be a serious
fault which might cause you to lose data if you
continue. Contact your support representative.
*Incorrect Drive A type – run SETUP – Type
of floppy drive A: not correctly identified in
Setup. This means that the floppy disk drive
type identified in your Setup Utility does not
agree with the type detected by the Power On
Self Test (POST). Run the Setup Utility to
correct the inconsistency.