FUJITSU LIFEBOOK 990TX2 - Manual (Page 149)

U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
139
LANdock
To install your notebook in a LANdock:
1. Put your notebook in Suspend mode or turn
off the power.
2. To use a docking device with your notebook
they both must be on a flat surface.
3. Remove all connections from the rear panel of
your notebook. (See Figure 1-7 on page 8.)
4. Make sure that the adjustment feet are flat
against the bottom of the notebook and the
covers of the connectors, both rear panel and
right side panel,are closed.
5. Make sure that the slide cover in the rear
panel is completely open.
6. Set your notebook on the leveler, making
sure that the alignment pins on the leveler
(Figures 4-17 and 4-19) fit into the Docking
Alignment receptacles in the bottom of your
notebook. (Figure 1-8 on page 10.)
7. Arrange the notebook/leveler combination to
align the docking connector on the docking
device body with the Docking port on your
notebook and the notches on the leveler with
the notches on the docking device body.
(Figure 4-16.)
8. Push together firmly.
9. Lock in place by pulling the Docking Release
lever forward.
10. Verify that docking is complete by checking
that the LifeBook Docked LED is illuminated.
(Figure 4-17.)
11. Return your notebook to operation using
the Suspend/Resume button or power
switch,as appropriate. (When setting up the
LANdock for the first time you must use the
power switch.)
Figure 4-16 Installing Your Notebook
in a Docking Device