FUJITSU LIFEBOOK 990TX2 - Manual (Page 146)

S e c t i o n F o u r
136
To Remove Memory Upgrade Modules:
1. Perform steps 1 through 6 of Installing
Memory Upgrade Modules.
2. Pull clips sideways from each side of the
memory upgrade module which you wish t o
remove.(Figure 4-15).
3. While holding clips out, remove the module
from the slot by lifting it up and pulling
towards the front of your notebook.
4.Store the memory upgrade module in a static
guarded sleeve.
5. Repeat the process for the second memory
upgrade module as required.
6. Replace the cover by following the
instructions in steps 12 through 14 of
the instructions for Installing Memory
Upgrade Modules, or install new memory
upgrade modules and then replace the cover
by following the instructions in steps 7
through 14 of the instructions for Installing
Memory Upgrade Modules.
C A U T I O N
Memory upgrade modules can be
severely damaged by electro-static
discharge (ESD). Be sure your are
properly grounded when handling and
removing the module.
Checking the Computer Recognition
of New Memory Capacity
When you have changed system memory capac-
ity by adding or removing memory upgrade
modules, be sure to check that your notebook
has recognized all of the active memory. You
can check memory capacity by looking at the
Main Menu of the setup utility:
1. Turn on power using the power switch.
2. Enter the setup utility by pressing the F2 key
as soon as the Fujitsu logo appears on the
screen. (See page 54.)
3. The System Memory and the Extended
Memory capacity, as detected by your note-
book during the Power On Self Test (POST),
are displayed at the bottom of the Main
Menu screen.
Example:A system with 32MB of memory
will display 640K System Memory, 31M
Extended Memory.