FUJITSU C150-E049-02EN - Manual (Page 131)

3-98 M3099GX/GH OEM Manual
A definition of the status byte codes is given below.
GOOD: This status indicates that the target has successfully
completed the command.
CHECK CONDITION: This status indicates that a contingent
allegiance condition has occurred(See ANSI SCSI-2 7.6).
BUSY: This status indicates that the target is busy. This status shall
be returned whenever a target is unable to accept a command from
an otherwise acceptable initiator (i.e., no reservation conflicts). The
recommended initiator recovery action is to issue the command
again at a later time.
RESERVATION CONFLICT: This status shall be returned
whenever an initiator attempts to access a logical unit or extent
within a logical unit that is reserved with conflicting reservation type
for another SCSI device (See RESERVE UNIT, RESERVE UNIT
commands). The recommended initiator recovery action is to issue
the command again at a later time (see ANSI SCSI-2 7.6).
#03.pm5 98.2.22, 1:33 PM 98