FUJITSU C150-E049-02EN - Manual (Page 213)

M3099GX/GH OEM Manual B-2
B.3 Contents of
the setup
mode
1 Setting double feed
detection
2 Setting IPC-2
pre-set
3 Reset of abrasion
counter
4 Setting buzzer
5 Setting pre-pick
6 Adjusting LCD
contrast
7 Setting pick speed
8 Setting initial value
of endorser
number
9 Setting method of
endorser reset
10 Reset of endorser
number
11 Reset of ink
counter
12 Setting SCSI-ID
13 Setting Product-ID
14 Setting picking
start time
15 Setting picking
time
16 Setting time-out
limit
Mode Setup type Contents
Set in EEPROM whether double feed detection
is done or not.
Set in EEPROM the pattern No. of IPC-2 pre-
set mode.
Reset the abrasion counter after Belt/Roller are
exchanged.
Set in EEPROM whethr the buzzer function is
on or off.
Set in EEPROM whether pre-picking is done
for fast reading or not.
Set in EEPROM the LCD contrast.
Set in EEPROM whether pick speed is fast or
slow.
Set the using of endorser and the initial
number. The set value is able to be stored in
EEPROM.
Set in EEPROM whether the number is reset
by hopper empty detection.
Reset the number to initial value.
Reset the ink counter after the print head has
be replaced.
Set the SCSI-ID (0–7).
Set the Product-ID.
(M3096G/M3099G/M3099GH)
Set in EEPROM the time from when the
hopper empty sensor is blocked in manual mode
until picking begins.
Set the time from when picking begins until the
SF1 sensor is blocked by paper.
Set the time from when a command is issued in
manual mode until paper is actually detected.
The setup mode can be classified into eighteen:
#A-3 Appendix B 98.2.22, 2:40 PM 2