FUJITSU C150-E049-02EN - Manual (Page 175)

4-18 M3099GX/GH OEM Manual
Replace the pick roller as follows:
1 Turn off the power switch.
2 Open the upper transport
unit. (See page 4-2)
3 Put off U shaped clips on
both ends of the pick roller
shaft. Pull the pick rollers
outward each other to
remove.
4 Install a new pick rollers
and put the U shaped clips
on the pick roller shaft.
5 Close the upper transport
unit. (See page 4-2)
Pick Roller
Replacement
Upper transport unit
Operator panel
Power switch
Lever
Pick roller
U shaped clip
Pick roller
section
White mark
NOTICE
When you install pick rollers,
make sure that the white
marks on the side of the both
pick rollers be in the right-
hand side of the scanner.