FUJITSU C150-E049-02EN - Manual (Page 209)

M3099GX/GH OEM Manual A-4
12 Press [Mode 2] to see Screen 10. You may see
current print number. If you want to reset the
number, press [Mode 2]. And you can see Screen
11 for 3 sec. If you don’t want it, press [Mode 1]
to go to Screen 9.
If you want to close the job, go to 7.
A2.5 How to reset the print head life counter
You must reset the print head life counter, when you replace the print head.
13 At Screen 1 press [Mode 1] eleven times to go to
INK RESET screen. (Screen 12)
14 Press [Mode 2] to see Screen 13.
If you want to reset the counter, press [Mode 2].
And you can see Screen 14 for 3 sec.
If you don’t want it, press [Mode 1] to go to
Screen 12.
If you want to close the job, go to 7 .
A2.6 How to test the printing by the operator panel operation
You can check the print result by the following procedures.
15 Set the endorser ON by the procedure of the
section A2.1.
16 While pressing the [Mode 2], turn the power of
the scanner on. Then the LCD displays the
MAINTENANCE MODE initial screen. (Screen
15)
RESET VALUE 0 0 0 0 1
No-Mode 1 Yes-Mode 2
Screen 10
RESET Finish !! 0 0 0 0 1
Screen 11
<< SETUP MODE >>
INK RESET
Screen 12
INK RESET
No-Mode 1 Yes-Mode 2
Screen 13
RESET Finish !!
Screen 14
<< CE MODE >>
TEST
××
: START
Screen 15