FUJITSU C150-E049-02EN - Manual (Page 224)

M3099GX/GH OEM Manual B-13
SETUP MODE
B3.17 Setting hopper time
When you set the hopper time, you must set as follows.
56 At Screen 2, press [Mode 1] seventeen times
to go to the HOPPER TIMER screen.
(Screen 34)
57 Press [Mode 2] to see Screen 35. (The default
setting is 7 sec.)
58 At Screen 35, press [Mode 1] until the digit
you want to change blinks. Then press [Mode
2] until the digit changes as you want. (The
specifiable range is from 0 to 30 sec. in 1 sec.
step.)
59 Press [Mode 1] and [Mode 2] at a time to see
Screen 34. The settings are stored to
EEPROM.
60 When you close the setup mode, go to 9 .
B3.18 Setting heater control
When you set the heater control, you must set as follows.
61 At Screen 2, press [Mode 1] eighteen times to
go to the HEATER CONTROL screen.
(Screen 36)
62 Press [Mode 2] to see Screen 37. If “ON” is
displayed, the heater control will be done. If
“OFF” is displayed, warming-up will finish
within 30 sec. necessarily.
When the heater is broken, please set “OFF”.
The “ON” or “OFF” status flips each time
you press [Mode 1]. The status will be set in
EEPROM automatically.
63If you want to return to Screen 36, press
[Mode 2]. When you close the setup mode,
go to 9 .
<< SETUP MODE >>
HOPPER TIMER
HOPPER TIMER
X X S
Screen 35
Screen 34
<< SETUP MODE >>
HEATER CONTROL
HEATER CONTROL
ON
Screen 37
Screen 36