FUJITSU C150-E049-02EN - Manual (Page 201)

8-6 M3099GX/GH OEM Manual
Cleaning the rollers with dry cloth and alcohol (Cleaner F1)
1 Open the upper transport
unit. (See page 4-2)
2 Wipe the pick rollers, belt
and the upper and lower
transport unit rollers with a
dry cloth or cloth soaked in
isopropyl alcohol.
3 Close the upper transport
unit. (See page 4-2)
Cleaning the steel rollers with cleaner F2
This cleaning is required when the toner stick to the roller.
1 Open the upper transport
unit. (See page 4-2)
2 Apply a small amount of
cleaner F2 to a Q-Tips.
While turning the roller
slowly, wipe its surface with
Q-Tips.
Cleaning the transport paths
Clean the transport paths as follows
1 Open the upper transport
unit. (See page 4-2)
2 Wipe the transport paths
with a dry cloth or cloth
soaked in isopropyl alcohol.
Use a vacuum cleaner when
removing paper dust from
the paths.
3 Close the upper transport
unit. (See page 4-2)
Feed roller
Upper transport
unit
Pick rollers
Lower transport unit Belt
Transport
paths
This roller exists only 1000 sheets
hopper type.
This roller exists only 1000 sheets
hopper type.