FARGO electronic Quatro ID Card Printer - Manual (Page 36)

32 Maintenance
2. With the printer power ON, open the Top Cover, but leave
the Printhead Assembly latched shut.
3. Remove the Cleaning CardÕs adhesive backing paper.
4. Press and hold the on/cancel button down. You will hear
the feed rollers begin to turn.
5. While holding down the on/cancel button, insert the
Cleaning Card into the Card Input Hopper and manually
push it into the printer until you feel the printerÕs middle
feed roller grab and begin feeding the card. When inserting
the cleaning card, be sure that the shortest non-adhesive
end of the Cleaning Card enters the printer first and that
the side of the cleaning card with the adhesive backing
removed (the sticky side) is facing upward. If the card is
inserted with the sticky side facing downward, it will stick
to the Card Input Tray and will not feed.
6. Keep pressing the on/cancel button until the Cleaning
Card has fed completely through the printer. Repeat this
cleaning procedure if necessary. After the cleaning
procedure is finished, re-install ribbon and cards and turn
the printer power OFF and ON to reset the printer.
NOTE: Once you have completed the above cleaning procedure, you should
also clean the printerÕs Drive Roller according to the steps in the
following section.
Sticky Side Up
Insert this end first
Quatro/510323 v3 1/8/99 10:48 AM Page 32