FARGO electronic Quatro ID Card Printer - Manual (Page 9)

Powering Up the Printer 5
II. IDENTIFYING THE PRINTER FEATURES
This illustration shows the features found on the front of your
Quatro ID Card Printer.
The on/cancel button turns the printer ON and OFF. It also
serves to cancel the current print job and reset the printer for
the next print job. If a card is left within the printer after a print
job is canceled, it will automatically be ejected when the printer
is turned back ON.
The on-line button takes the printer on and off-line. The
printer must have the on-line light illuminated in order to
print. When flashing, the on-line light also serves to indicate
a print error condition. Such conditions are discussed in
Chapter 6 of this manual.
The Card Input Hopper is where blank cards are loaded. See
Chapter 3, Section IV for complete instructions on loading
cards.
The Card Output Hopper is where printed cards eject. An
Attachable Card Output Hopper is included with your printer
and serves to catch cards once they have finished printing. To
attach this hopper, simply open the Top Cover of the printer
and slip it over the edge of the printerÕs baseplate. Once the
Top Cover is closed, it will hold the hopper securely in place.
The Top Cover tilts from front-to-back to open and is how you
access the inside of the printer to load cards and ribbon. See
Chapter 3 for an illustration of how this cover opens as well as
for instructions on loading print supplies. Note that the Top
Cover must be shut in order for Quatro to print.
On/Cancel Button
On-Line Button
Top Cover
Card Input Hopper
On-Line LED Light
On/Cancel LED Light
Card Output
Hopper
Quatro/510323 v3 1/8/99 11:06 AM Page 5