FARGO electronic Quatro ID Card Printer - Manual (Page 8)

4 Powering Up the Printer
2. Plug the DC power plug end of the transformer cord into
the Power Input Port on the rear panel of Quatro.
NOTE: Optional external transformer must be a Listed Class 2 device with an
output rating of 16.5 volts and 3.5 amps AC (alternating current).
The alternating current should be between 50 and 60 Hz.
3. Plug the AC power plug end of the transformer cord into an
available wall outlet. The wall outlet should be located near
the printer and should be easily accessible.
Power is automatically applied to the printer when it is
plugged in. Press the on/cancel button if you wish to turn
the printer OFF.
Power Input Port
Quatro/510323 v3 1/8/99 10:48 AM Page 4