Fostex D-108 - Manual (Page 107)

107
D-108 Owner’s Manual (Changing the initial setting <SETUP mode>)
“NOs Of Event ?” menu
“Drive Sel. ?” menu
“Load PGM ?” menu
“Save PGM ?” menu
“Disk Format ?” menu
“Track Exchange ?” menu
“Signature Set?” menu
“Tempo Map Set ?” menu
“Title Edit ?” menu
“Delete PGM ?” menu
“Click ?” menu
“Preroll Time?” menu
“MIDI Sync out?” menu
“Frame Rate ?” menu
“MTC OFFSET ?” menu
“ Offset Mode ?” menu
“Slave Mode?” menu
“Ref. TC?” menu “Rec Protect ?” menu
“Digi. in ?” menu
“Sync Preset ?” menu
“Slave Type ?” menu
The following diagram shows the position of each menu.
1. While the D-108 is stopped, switch to the SETUP
display by pressing the DISP SEL key, and then
press the EXECUTE/YES key.
The SETUP display stops flashing. This is the first step in
the SETUP mode.
The position of the SETUP menu that you choose wikk
start flashing on the level meters. Each SETUP menu has
a dedicated position in the FL tube display.
This indicates the position of the SETUP menu. Selecting a
menu via the JOG dial will move the flashing cursor.
The title of the SETUP menu
appears. You can select a different
menu via the JOG dial. This lights up when the FD-8
enters SETUP mode.
Note: With the factory initial settings, or when you turn on the
power again after you format a current drive disk, “Drive Sel?
(Setting a current drive)” appears. Otherwise, the first hierarchy
level of the previously-selected SETUP menu appears.
2. Select the desired menu using the JOG dial, then
press the EXECUTE/YES key.
The D-108 displays the second hierarchy level of the
selected SETUP menu, where you can set parameters.
“Sample Rate?” menu
“Device ID ?” menu
“ Resolu ?” menu
“Digi. out ?” menu
“Clock Sel. ?” menu
Not Used !
Note: This feature also shows these two menus; “Ref. TC ?”,and “Sync Preset ?”. However, since these menus will only work when the
optional accessory Model 8345 is installed, there is no explanation of these functions in manual. Refer to the Model 8345 manual for details.
To exit SETUP mode, press the STOP button or the EXIT/
NO key. Each time you press one of these keys, the D-108
returns to the previous hierarchy level of the menu, and
finally exits SETUP mode.
44.1kHz
SETUP
8 7 6 5 4 3 2 1
42
OL
0
30
24
18
12
9
6
3
∞
Selecting SETUP mode
Follow the steps below to select the desired SETUP menu in SETUP mode.