Fostex D-108 - Manual (Page 76)

D-108 Owner’s Manual (MIDI Synchronization)
76
Setup of D-108
1.Because the MIDI clock and song position pointer will be output from the D-108, set the SETUP mode "MIDI sync
signal output setting" to "CLK."
* Initial setting: CLK
* Permissible setting: CLK (MIDI clock and song position pointer:"CLK")
MTC (MIDI time code: "MTC")
Off (No output of MIDI sync signal)
* This item can be setup for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "112", SETUP mode "MIDI sync signal output setting" for correct operating procedures.
2.The meter in the desired bar can be set by "Time signature setting" of the SETUP mode.
* Initial setting: 001 bar, 4/4 signature.
* Permissible bar setting: 001~999
* Permissible meter setting: 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8, -- -- (Elimination of signature)
* Permissible setting of maximum number of points: 64 points
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "108", SETUP mode "Time Signature Setting" for operating procedure.
3.Tempo in the desired bar can be set by "Tempo setting" of the SETUP mode.
Tempo map is made in steps 2 and 3.
* Initial setting: 001 bar, 1st meter, Tempo120.
* Permissible bar setting: Follows the previous "Setup of the time signature."
* Permissible signature setting: Follows the previous "Setup of the time signature."
* Permissible setting of tempo: Quarter note=30~250 .... (Tempo elimination)
* Permissible setting of maximum number of points: 64 points
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "109", SETUP mode "Tempo Setting" for operating procedure.
4.Set the SETUP mode "Metronome setting" to ON if click sound is to be output according to the setup tempo map.
* Initial setting: Off
* Permissible setup item: Off, On
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "111", SETUP mode "Metronome setting" for operating procedure.
5.Press the DISP SEL key while pressing the EXECUTE/YES key, and then change the time base display to BAR/
BEAT/CLK.
Confirming the MIDI clock sync
During recording and at playback following the recording, the time base (BAR/BEAT/CLK) is displayed in accor
dance to the setup tempo map, and the MIDI clock and song position pointer is also output.
Confirm that the travel position (BAR/BEAT/CLK) of the D-108 and the travel position of the synchronized MIDI
sequencer are matched.