Fostex D-108 - Manual (Page 81)

D-108 Owner’s Manual (MIDI Synchronization)
81
3.With the SETUP mode "MTC offset mode setting," whether the MTC offset time will be output (ABS) at the ABS
00h 00s 00f 00sf point or at the 001BAR 1BEAT 00CLK (bar/signature) point of the tempo map, is selected.
# Refer to page "114", SETUP mode "MTC offset mode setting" for operating procedure and details.
4.A random offset time is set by the SETUP mode "MTC offset time setting."
# Refer to page "113", SETUP mode "MTC offset time setting" for operating procedure and details.
5."00" is set with the SETUP mode "MIDI device ID setting."
# Refer to page "120", SETUP mode "MIDI device ID setting" for operating procedure and details.
6.Set to "adat" the digital signal to be output by the SETUP mode "Digital output track setting."
# Refer to page "119", SETUP mode "Digital output track setting" for operating procedure and details.
7.Press the DISP SEL key while pressing the EXECUTE/YES key to change the time base display to MTC.
Setup of D-108 (#2) <Slave 1> and D-108 (#3) <Slave 2>
1.Set the SETUP mode "MTC Frame rate setting" to the same frame rate as in D-108 (#1).
* Refer to page "113", SETUP mode "MTC Frame rate setting" for operating procedure and details.
2.Set the SETUP mode "MTC offset mode setting" to the same mode as in D-108 (#1).
# Refer to page "114", SETUP mode "MTC offset mode setting" for operating procedure and details.
3.Set the SETUP mode "MTC offset time setting" to the same offset time as in D-108 (#1).
# Refer to page "113", SETUP mode "MTC offset time setting" for operating procedure and details.
4.Set the SETUP mode "MIDI device ID setting," to "01" in D-108 (#2), and to "02" in D-108 (#3).
# Refer to page "120", SETUP mode "MIDI device ID setting" for operating procedure and details.
5.Using the SETUP mode "Slave mode setting," set slave mode to "On," and the SETUP mode "Slave mode type
setting," the slave type to "adat."
* Slave mode initial setting: Off
* Permissible setup item: On, Off
* Slave type initial setting: Vari
* Permissible setup item: Vari, SP DIF, adat, Free
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "115", SETUP mode "Slave mode setting" , and to page "116", SETUP mode "Save mode type setting",
for operating procedure and details.
6.Press the DISP SEL key while pressing the EXECUTE/YES key to change the time base display to MTC.
<Note>
After this setup, check the following in D-108 (#2) and D-108 (#3).
* Blinking of "CHASE" in the display: This will change to constant lit upon completing chase lock in later operation.
* "DIGITAL" is lit in the display: This means it is externally synchronized against the input digital signal.
<Note>
Do not insert or remove the optical cable connected to DATA IN when the slave mode is set to "On." Doing so could generate
noise and affect external equipment.