Fostex D-108 - Manual (Page 12)

D-108 Owner's Manual (Names and Functions)
12
22. Recall key [RECALL]
Press this key to recall the stored time value (or Bar/Beat/
Clock value). Pressing this key, and then one of the
following keys will display the data stored at the key you
pressed, and you will be able to edit the data.
The Clipboard In point is recalled and the D-108
enters the edit mode.
The Clipboard Out point is recalled and the D-
108 enters the edit mode.
The Auto Punch In point is recalled and the D-
108 enters the edit mode.
The Auto Punch Out point is recalled and the D-
108 enters the edit mode.
The Auto Return Start point is recalled and the
D-108 enters the edit mode.
The Auto Return End point is recalled and the
D-108 enters the edit mode.
Press the EXIT/NO key, or STOP button to escape from
the edit mode (including vari pitch setup mode).
If you press the desired memory key while depressing
the RECALL key, you can preview the fade-in/fade-out
point stored in the memory key.
And, using [Press LOCATE: **] displayed after pressing
the STORE key, this information can also be registered in
a desired locate number (00~99).
* Refer to page "68" for more information about the clipboard.
* Refer to page "39" for more information about Auto Punch In/
Out recording.
* Refer to page "61" for more information about Auto Return.
* Refer to page "65" for more information about Preview function.
23. Store key [STORE]
This key is used to store a time value (or Bar/Beat/Clock
value) to one of the memory keys. Pressing this key, and
then one of the following keys will cause the data shown
on the display to be stored to the corresponding memory
key you pressed. Pressing the STORE key while holding
down the HOLD/> key will change a Program.
Data is stored as a Clipboard In point. The stored
data can be used as a locator.
Data is stored as a Clipboard Out point. The
stored data can be used as a locator.
Data is stored as an Auto Punch In point. The
stored data can be used as a locator.
Data is stored as an Auto Punch Out point. The
stored data can be used as a locator.
Data is stored as an Auto Return Start point. The
stored data can be used as a locator.
Data is stored as an Auto Return End point. The
stored data can be used as a locator.
After pressing this key, if you wish to cancel the store
operation, press the EXIT/NO key, or STOP button.
And, using [Press LOCATE:**] displayed after pressing the
RECALL key, data stored in the desired locate number
(00~99) can be recalled.
* Refer to page "20" and "36" for more information about Program
Change function.
* Refer to page "60" for more information about the Locate
function.
* Refer to page "39" for more information about Auto Punch In/
Out recording.
* Refer to page "61" for more information about Auto Return.
RECALL key -> CLIPBOARD IN key
RECALL key -> CLIPBOARD OUT key
RECALL key -> AUTO PUNCH IN key
RECALL key -> AUTO PUNCH OUT key
RECALL key -> AUTO RTN START key
RECALL key -> AUTO RTN END key
RECALL key -> VARI PITCH key
The Vari Pitch data is recalled and the D-108
enters the edit mode.
RECALL key -> LOCATE key
The Locate key data is recalled and the D-108
enters the edit mode.
STORE key -> CLIPBOARD IN key
STORE key -> CLIPBOARD OUT key
STORE key -> AUTO PUNCH IN key
STORE key -> AUTO PUNCH OUT key
STORE key -> AUTO RTN START key
STORE key -> AUTO RTN END key
Data is stored as a LOCATE key data.
STORE key -> LOCATE key