Fostex D-108 - Manual (Page 111)

111
D-108 Owner’s Manual (Changing the initial setting <SETUP mode>)
Metronome Setting ("Click ? ")
The D-108 is able to generate the metronome click tone according to the tempo map figured out by the time signature and tempo
setting. You can record a track at the same time as listening to the metronome click tone.
If you set this mode to ON, track 8 will generate the metronome click tone in either play or record mode.
<Note>
If you set this mode to ON, the D-108 cannot playback the recorded sound from track 8, as track 8 will be the click track exclusively.
In conjunction with this, do not record track 8 with this mode on. If track 8 is in record mode, the click will not be generated.
* Initial setting : Off
* Available setting : Off, On
* The setting is applicable song by song.
* The setting can be saved or loaded as a part of song data
* The setting is memorized even when the power is off.
* Make sure to choose the right program before setting up this mode.
1. Press the DISP SEL key and choose the flashing SETUP
mode on the display. Then, press the EXECUTE/YES key.
The SETUP display stops flashing.
2. With the JOG dial, choose "Click ?".
The "?" display will start flashing.
3. Press the EXECUTE/YES key.
The display will start flashing either "Off" or "On" of current
setting. In the case of initial setting it will show "Off".
4. Choose either ON or OFF with the JOG dial.
On Click tone will be generated.
Off Click tone will not be generated.
5. Press EXECUTE/YES key after choosing the setting you want.
44.1kHz
SETUP
8 7 6 5 4 3 2 1
42
OL 0
30 24 18 12 9 6 3
∞
* Press either the "STOP" button or EXIT/NO key to re-
turn from the second step menu to the first or to quit
SETUP mode. The menu will go backwards each time you
press either key so that you can correct the setting, choose
some other SETUP mode or eventually return to the nor-
mal time base display.
Preroll Time Setting ("Preroll Time ? ")
The D-108 has a preroll function, which stops at the backwards specified time location. This function is useful when you want to start
monitoring the recorded audio from just before a locate point.
* Initial setting : 00sec
* Available setting : 00 ~10sec in 1sec step
* The setting is applicable song by song.
* The setting can be saved or loaded as a part of the song data.
* The setting is memorized even when the powering off.
* Make sure you choose the right program before setting up this mode.
Locate point (stored in the memory key) This point is actually located.
This point is located if the current position is before
the locate point.
This point is located if the current position is after the locate point.
Preroll time (before the locate point) can be set between 00 and 10 seconds.
44.1kHz
SETUP
8 7 6 5 4 3 2 1
42
OL 0
30 24 18 12 9 6 3
∞