Genicom LA36 - Manual (Page 30)

2-15
Paper Handling
Positioning the Paper Stack
Place the stack of continuous forms paper directly below the rear of the printer
1 11 11 for push,
rear feed or below the bottom slot of the printer
2 for pull, bottom feed.
Caution: When using paper-stapled multipart forms in push feed, raise the cut sheet stand
3.
After the paper is installed in the printer, the paper path should look like this:
Good placement
Push-feed, from rear slot Push-feed, from rear slot
with paper-stapled multipart forms
Pull-feed, from bottom slot
Bad placement
Placement of Continuous Forms
1
2
3