Genicom LA36 - Manual (Page 89)

4-32
Using Set-Up Mode
3. Examine the test page.
A sample test page is shown in step 5, “Testing the Printer,” in the Installation Guide.
Hex Dump Mode
The Hex Dump mode prints data and commands in hexadecimal characters and abbreviated
control codes. The ASCII characters are used for printing. No characters are printed for
hexadecimal codes 80 to FF. The Hex Dump mode is useful for checking whether your
computer is sending the correct commands to the printer and whether the printer is
executing the commands correctly. It is also useful for debugging software programs.
To start the Hex Dump mode, make sure that continuous forms paper is loaded into the
printer. Enter the Set-Up mode and follow these steps:
1. Start the Hex Dump mode (select the HEX-DUMP option).
Repeatedly press the button to position the red cursor under HEX-DUMP , and then
press the button or the button. The printer selects (underlines) HEX-DUMP , enters
the Ready state and prints a header at the top of the page.
Note: You cannot switch back to Set-Up mode from Hex Dump mode. Do not change
any value before entering Hex Dump mode because your changes will be lost.
2. Print the hex dump.
To start hex dump printing, send your file or program to the printer. The printer goes
online and prints the hex dump.
Press the Pause button to pause and resume printing in Hex Dump mode. To resume hex
dump printing, press the Pause button again.
To print another hex dump, send another file to the printer.
3. Exit the Hex Dump mode
Turn the printer off to exit the Hex Dump mode.
Caution: If you change any settings in the Set-Up mode before starting the Hex Dump
mode, these changes will be lost.