Genicom LA36 - Manual (Page 77)

4-20
Using Set-Up Mode
MACRO 1 and
MACRO 2 Options Values Description
=DEC DEFLTS========= The following are the Set-Up options for the DEC
PPL2 protocol only.
<DEC PRT ID> Specify the printer ID to be given in response to DA
commands from the computer.
LA50 ID
LA120 ID
LA210 ID
<AUTO WRAP> TRUNCATE Characters are received but not stored in the print
buffer.
WRAP End-of-line wrap. Causes a Carriage Return plus a
Line Feed.
<EOT DISCON> Specify whether the DSR signal is controlled by the
EOT character (DEC-423 serial interface only).
NO DISCON EOT character is ignored.
DISCONNECT DTR signal turns low for five seconds when the EOT
character is detected.
<INIT REPRT> Specify whether the status is sent to the computer
when the printer is turned on (DEC-423 serial
interface only).
NO Status is not sent.
YES Status is sent.
<AUTO ANSBK> Specify whether the ANSWERBACK message is sent
to the computer when printer is turned on.
NO ANSWERBACK message is not sent.
YES ANSWERBACK message is sent.
<ANSWER ENQ> Specify whether the ANSWERBACK message is sent
to the computer when printer receives an ENQ code.
N O ANSWERBACK message is not sent.
YES ANSWERBACK message is sent.
(DEC Defaults)
(DEC Printer ID)
(End of Transmis-
sion Disconnect)
(Initialization
Report)
(Automatic
ANSWERBACK)
(ANSWERBACK
on ENQ)