Points to remember, Printing the printer configuration – Genicom LA36 User Manual
Page 68
4-11
Using Set-Up Mode
Points to Remember
•
We recommend that you use continuous forms paper for printing in the Set-Up mode
because the output will exceed a single page. To load paper, use the
FF/Load
button. To
adjust the line position of the paper in the Set-Up mode, use the platen knob.
•
Whenever you enter the Set-Up mode, short help menus are printed at the top of the
page. Help menus are also printed when you select the
TESTS
function. Use the help
menus for quick reference while in the Set-Up mode.
•
When printing the options and values for each function, you can move either forward or
backward in the option list. To move forward (print the next option), press the
button.
To move backward (print the previous option), press the
button. You can skip printing
the value list for the undesired options by pressing and holding down these buttons.
•
While in the
<FUNCTIONS>
menu or when selecting a function that contains options
and selectable values, press the
Exit/Save
button to reprint the
<FUNCTIONS>
menu. In
this case, the red cursor is positioned beneath
SAVE&EXIT
.
•
A bolded (overprinted) value indicates that it is the current setting. An underlined value
indicates a selected setting.
•
While in the Set-Up mode, you can use the
function to print out a list of the
currently selected values. (See the next section for details.)
•
To exit the Set-Up mode and permanently save your changes, select the
SAVE&EXIT
function. For details, see the section, “Exiting and Saving,” later in this chapter
•
To exit the Set-Up mode and temporarily use your changes, press the
Set-Up/Quit
button.
Your previous power-on settings will be active when you turn the printer on again.
Printing the Printer Configuration
The
function prints a list of all the printer’s currently selected values. This function
is useful for checking the printer settings when you first enter the Set-Up mode or just
before you exit. To print a list of values, first load continuous forms paper, and then enter
the Set-Up mode to select the
function. The printer starts to print a list of the
currently selected values. The pre-selected factory settings are shown on the opposite page.
When the printer finishes printing the list of values, it reprints the
<FUNCTIONS>
menu.
Caution:
To remove the printout, turn the platen knob until the paper can be torn off at the
perforation. In the Set-Up mode, you cannot use the printer tear-off feature
(
Pause
button).
Select another function or exit the Set-Up mode, saving any changes you made. For details
about other functions, see the other sections in this chapter. To exit the Set-Up mode and
save your changes, make sure that the red cursor is positioned beneath
SAVE&EXIT
, then
press the
button or the
button.