Genicom LA36 - Manual (Page 83)

4-26
Using Set-Up Mode
INSTALL Options and Values
• Overprinted values are the factory settings.
I N S T A L L
Options Values Description
<LANGUAGE> Specify a language to be used to print the Set-Up
menu functions and options.
ENGLISH English
DEUTSCH German
ESPANOL Spanish
FRANCAIS French
ITALIANO Italian
<TEAR> Specify the (auto) start timing of tear off feeding.
AUTO 1 SEC 1 second after data stops from the computer
AUTO 2 SEC 2 seconds after data stops from the computer
AUTO 3 SEC 3 seconds after data stops from the computer
AUTO 4 SEC 4 seconds after data stops from the computer
AUTO 5 SEC 5 seconds after data stops from the computer
MANUAL Feed the paper for tear-off when the Pause button is
pressed.
NO TEAR Tear off feeding is inhibited under any conditions.
Specify this setting for labels that tend to peel off
during backward feeding.
<S-SHEET LD> Specify the (auto) start timing of single sheet loading.
AUTO 1 SEC 1 second after a single sheet is set on the platen
AUTO 2 SEC 2 seconds after a single sheet is set on the platen
AUTO 3 SEC 3 seconds after a single sheet is set on the platen
AUTO 4 SEC 4 seconds after a single sheet is set on the platen
AUTO 5 SEC 5 seconds after a single sheet is set on the platen
MANUAL Load a single sheet when the FF/Load button is
pressed.
<ERROR BEEP> Enable or disable the printer status buzzer when a
fault condition occurs.
ONE One beep for a period of about 500 ms
CONTINUOUS Buzzer on until the fault condition is cleared
OFF Buzzer off under any condition
(Single Sheet
Load)