Genicom LA36 - Manual (Page 33)

2-18
Paper Handling
8. Fit the paper feed holes onto the left and right tractor pins. Adjust the left forms tractor
(as seen from the rear of the printer) to accommodate the width of the form. Close the
paper holders
6.
Adjusting Paper Tension
9. Pull the left tractor (as seen from the rear) to extend the paper flat. Do not stretch the
paper taut. Push the left locking lever down to secure the tractor in place. Unlock the
back cover from the cut sheet stand to close it.
10. When using paper-stapled multipart forms, leave the cut sheet stand
3 raised in the up
position. For other continuous forms paper, lower the cut sheet stand to the down
position.
Lowering the Cut Sheet Stand
11. Press the FF/Load button to advance the paper to the top-of-form position from which
printing can start. The printer is automatically placed in the Ready state.
6
3