Genicom LA36 - Manual (Page 66)

4-9
Using Set-Up Mode
3. Print the menu of the left margin option.
Since you only want to change the left margin, press the button to select the current
protocol. The bolded PORT DEPND is underlined, and the next option <PRTCL SERL>
is printed. (The bolded value indicates the current setting, and the underlined value is the
new setting.) Repeatedly press the
button until the <LEFT MARGN> option and its
value are printed.
4. Change the left margin from column 1 to column 20.
Press and hold the button until the printer beeps nineteen times. When the button is
released, the new value is printed next to the current value. If the new value is not
20 COL , repeat this operation. If it is 20 COL , press the button to select 20 COL .
20 COL is underlined, and the next option, <TOP OF FRM>, and its value are printed.
5. Exit the Macro 2 function.
Since you do not want to make any other changes in MACRO 2 , press the Exit/Save
button. The <FUNCTIONS> menu is then reprinted, and the red cursor is positioned
beneath SAVE&EXIT .
6. Exit the Set-Up mode, saving or not saving the new left margin.
Press the button or the button to save 20 columns as the new power-on default in
Macro 2 and exit Macro 2. The printer then exits the Set-Up mode and returns to the
Ready state. These settings remain in effect until the next time they are changed.
Press the Set-Up/Quit button if you do not intend saving these settings in Macro 2.
Options with Both Pre-determined and Undetermined Values
Some options include both types of values. Undetermined values appear at the end of the list
of pre-determined values, identified by the unit of the corresponding range.
For example, when you select the <FORM LENGH> option (Form Length), the following
menu is printed:
<FORM LENGH>
3 INCHES 3.5 INCHES 4 INCHES 5.5 INCHES 6 INCHES 7 INCHES 8 INCHES 8.5 INCHES 11 INCHES
11 2/3INCH 12 INCHES 14 INCHES 15 INCHES No of LINE
1. Select the No of LINE value.
A new option menu with undetermined values is printed.
2. Change the value according to the previous procedure.
The chart on the next page summarizes how to select options such as protocol and font and
how to use the functions that do not have options.