Genicom LA36 - Manual (Page 63)

4-6
Using Set-Up Mode
The first four Macro 1 options and their values are shown below. Options are shaded
and skipped when they are not objects of selection because of the preceding option
setting.
< P R O T O C O L >
DEC PPL2
IBM PPX24 EPSON-ESCP AUTO PORT DEPND
<PRTCL SERL>
DEC PPL2__ IBM PPX24
EPSON-ESCP
<PRTCL PARL>
DEC PPL2
IBM PPX24 EPSON-ESCP
<FONT>
DRAFT
HIDRAFT HI-IMPACT COURIER PICA PRESTIGE COMPRESSED BOLDFACE TIMELESS
NIMBUS-SAN OCR A OCR-B
3. Pressing and holding down the or button prints options and their current values
letting you skip selection of values so that you can reach the desired option quickly.
<FUNCTIONS>
MACRO 1 MACRO 2 PRINT INSTALL ADJUST TESTS RCALL-FACT MENU-ACCESS SAVE&EXIT
<PROTOCOL> PORT DEPND
<PRTCL SERL> DEC PPL2
<PRTCL PARL> EPSON-ESCP
<FONT> DRAFT
<HORZ PITCH> 10 CPI
<VERT PITCH> 6 LPI
<VERT PITCH>
2 LPI
3 LPI 4 LPI 6 LPI 8 LPI 12 LPI 1 LPCM 2 LPCM 4 LPCM
The current option and its values are reprinted when the or button is released.
Options with Pre-determined Values
For some options, you can choose among a limited set of pre-determined values. To select
such a value:
1. Repeatedly press the button or the button to position the red cursor on the
plastic print guide under the value you require.
2. Press the button to select the value. The printer prints the next option and its values.
You can press the button to select the value. Then the printer prints the previous
option and its values.