Genicom LA36 - Manual (Page 57)

3-10
Printing
will turn off and the printer resumes printing.
Caution: For continuous forms paper, the page where printing stopped and the page
where printing resumes may be incorrectly printed. In this case, wait for the
entire job to finish printing. Then reprint the incorrect pages.
Removing Printed Pages
This section describes the best methods for removing single sheets or continuous forms
paper after printing.
Removing Single Sheets
When you print using software, the printer automatically ejects each sheet of paper when the
end of the printed page is reached. To eject sheets manually:
• Press the FF/Load button to execute a form feed.
Removing Continuous Forms
To avoid wasting paper when removing printed continuous forms paper, use the printer's
tear-off function.
Depending on the TEAR option value of the Set-Up, the printer automatically feeds the
paper so that the perforation faces the tear bar. Tear the paper off. The paper will
automatically return to the Top-of-Form position when the printer receives data to print.
If you have set the TEAR option to MANUAL , you have to press the Pause button to move
the paper to the tear bar, and then to return the paper to the Top-of-Form position.
Note: See the section, “Tearing Off Continuous Forms,” in Chapter 2, “Paper
Handling.”