3controls & displays, Front panel, English – Marantz DV9600 User Manual
Page 13
3
Controls & Displays
13
English
Front panel
1
2
3
4
5
6
7
8
9
!
= ~
-
0
1 STANDBY indicator
• Lights when the unit is in standby.
2 Disc tray
• Place the disc here.
3
3 (PLAY)
• Begin the disc play.
4
7 (STOP)
• Stops the disc play.
5
8 (PAUSE)
• Pausing the disc play.
6 POWER ON/OFF
• Press to turn the power on, and press it again
to turn the power off.
7 HDMI/DVI RESOLUTION
• The HDMI on/off state toggles when pressed
for three seconds or more. When on, the
display indicates HDMI ON; when off, it
indicates HDMI OFF.
• Pressing this button while HDMI is enabled
displays the current resolution. Pressing this
button again while the resolution is displayed
allows you to select the resolution in the
sequence below:
480i/576i
480p/576p
720p
1080i
1080p
480i/576i
An asterisk (*) precedes resolutions supported
by the connected TV. For example: *720p
See page 52 for more details.
Note
• HDMI ON is set when the unit is shipped from
the factory.
• Set HDMI under the Setup menu to use HDMI
functions (see page 52).
8 Display – page 14
• Operation indications are displayed here.
9 Dolby Head Phone Mode
• Each time it is pushed, the operation changes as
shown below.
DH 1:
Reproduces a room that is small with little
reverberation.
DH 2:
Reproduces a room with more
reverberation than DH1.
DH 3:
Reproduces a larger room than DH1.
Bypass: It outputs normal Audio Sound without
Dolby effect.
10
0 (OPEN/CLOSE)
• Press to open and close the disc tray.
11 Head Phone Jack
• Connect the head phone.
Note
• Audio is not output from the analog audio jacks
or the HDMI jack when headphones are being
used.
• Audio is not output from the headphone jack
when i.LINK is in use.
12
4 /1
• Press to skip reverse title/group, chapter, or
track. You can also press and hold this button to
scan the above.
13 Head Phone Level
• Adjust the output of the head phone.
• When using the Head Phone, Analog audio
output and HDMI audio output cannot be
output.
14
¡/¢
• Press to skip forward title/group, chapter, or
track. You can also press and hold this button to
scan the above.