Multi-Tech Systems MVP210-SS - Manual (Page 14)

Overview MultiVOIP User Guide
14
for the MVP810SS) constitutes a practical limitation on their capacity to
support PSTN access for other gateways. Systems must be scaled to
match required capacity by including additional MultiVOIP-SS units.
Mounting. Mechanically, the MVP410SS and MVP810SS MultiVOIPs
are designed for a one-high industry-standard EIA 19-inch rack
enclosure. The product must be installed by qualified service personnel
in a restricted-access area, in accordance with Articles 110-16, 10-17, and
110-18 of the National Electrical Code, ANSI/NFPA 70.
Phone System Transparency. These MultiVOIPs inter-operate with a
telephone switch or PBX, acting as a switching device that directs voice
and fax calls over an IP network. The MultiVOIPs have “phonebooks,”
directories that determine to who calls may be made and the sequences
that must be used to complete calls through the MultiVOIP. The
phonebooks allow the phone user to interact with the VOIP system just
as they would with an ordinary PBX or telco switch. When the
phonebooks are set, special dialing sequences are minimized or
eliminated altogether. Once the call destination is determined, the
phonebook settings determine whether the destination VOIP unit must
strip off or add dialing digits to make the call appear at its destination
to be a local call.
Voip Protocol. The MVP-SS units use the SIP protocol only. (“SIP”
means Session Initiation Protocol.)
Data Compression & Quality of Service. The analog MultiVOIP unit
comes equipped with a variety of data compression capabilities,
including G.723, G.729, and G.711 and features DiffServ quality-of-
service (QoS) capabilities.
PSTN Failover Feature. The MultiVOIP can be programmed to divert
calls to the PSTN temporarily in case the IP network fails.
RADIUS Support. Inter-operation with a RADIUS server allows for
call accounting (especially for billing) on a voip system. The MultiVOIP
supports inter-operation with RADIUS servers for the RADIUS
accounting function (but not the RADIUS authentication function).
STUN Support. The STUN protocol (Simple Traversal of UDP through
NATs (Network Address Translation)) assists with the packet routing
functions of devices behind NAT firewalls or routers. The MultiVOIP
supports inter-operation with STUN servers and NATs (SIP based
environment only).
Management. Configuration and system management can be done
locally with the MultiVOIP configuration software. After an IP address
has been assigned locally, other configuration can be done remotely
using the MultiVOIP web browser GUI. Remote system management
can be done with the MultiVoipManager SNMP software or via the