Multi-Tech Systems MVP210-SS - Manual (Page 57)

MultiVOIP User Guide QS: Connectivity Test
57
4. You now need to free up the COM port connection (currently being
used by the MultiVOIP program) so that the HyperTerminal program
can use it. To do this, you can either (a) click on Connection in the
sidebar and select “Disconnect” from the drop-down box, or (b) close
down the MultiVOIP program altogether.
5. Open the HyperTerminal program.
6. Use HyperTerminal to receive and record console messages from the
MultiVOIP unit. To do so, set up HyperTerminal as follows (setup
shown is for Windows NT4; details will differ slightly in other MS
operating systems):
 In the upper toolbar of the HyperTerminal screen, click on
the Properties button.
 In the “Connect To” tab of the Connection Properties
dialog box, click on the Configure button.
 In the next dialog box, on the “General” tab, set
“Maximum Speed” to 115200 bps.
 On the “Connection” tab, set connection preferences to:
Data bits : 8
Parity : none
Stop bits : 1
 Click OK twice to exit settings dialog boxes.