Multi-Tech Systems MVP210-SS - Manual (Page 160)

Technical Configuration MultiVOIP User Guide
160
The Custom Tone-Pair Settings fields are described in the table below.
Custom Tone-Pair Settings Definitions
Field Name Values Description
Tone Pair dial tone,
busy tone,
ring tone,
‘unobtainable’
tone,
survivability
tone,
re-order tone Identifies the type of telephony
signaling tone for which
frequencies are being specified.
TONE PAIR VALUES About Defaults : US telephony
values are used as defaults on
this screen. However, since this
dialog box is provided to allow
custom tone-pair settings,
default values are essentially
irrelevant.
Frequency 1 frequency in
Hertz Frequency of lower tone of pair.
This outbound tone pair enters
the MultiVOIP at the input port.
Frequency 2 frequency in
Hertz Frequency of higher tone of pair.
This outbound tone pair enters
the MultiVOIP at the input port.
Gain 1 gain in dB
+3dB to –31dB
and “mute”
setting Amplification factor of lower
frequency of pair. This figure
describes amplification that the
MultiVOIP applies to outbound
tones entering the MultiVOIP at
the input port. Default = -16dB
Gain 2 gain in dB
+3dB to –31dB
and “mute”
setting Amplification factor of higher
frequency of pair. This figure
describes amplification that the
MultiVOIP applies to outbound
tones entering the MultiVOIP at
the input port. Default = -16dB