Multi-Tech Systems MVP210-SS - Manual (Page 91)

MultiVOIP User Guide Technical Configuration
91
Functional Equivalence of Interfaces. The MultiVOIP configuration
program is required to do the initial configuration (that is, setting an IP
address for the MultiVOIP unit) so that the VOIP unit can communicate
with the MultiVoipManager program or with the web browser GUI.
Management of the VOIP after that point can be done from any of these
three programs since they all offer essentially the same functionality.
Functionally, either the MultiVoipManager program or the web
browser GUI can replace the MultiVOIP configuration program after
the initial configuration is complete (with minor exceptions, as noted).
WARNING: Do not attempt to interface the MultiVOIP unit with
two control programs simultaneously (that is, by
accessing the MultiVOIP configuration program via
the Command Port and either the
MultiVoipManager program or the web browser
interface via the Ethernet Port). The results of using
two programs to control a single VOIP
simultaneously would be unpredictable.