Muratec MFX-2590 - Manual (Page 219)

3-136 Setting Security
Setting Description Settings
IP Address
Filtering Set the IP addresses to restrict. −
Setting *1 Select the basic policy for the access restrictions.
Select either “Reject all specified address(es)
except for those listed below” or “Authorize all
address(es) except for those listed below”.
Select “Available setting” to enable the settings. Reject all specified
address(es) except
for those listed below
Authorize all
address(es) except
for those listed below
IP Address List
(IPv4)
*2
Enter the IPv4 addresses (specified individually,
with a mask, or with a range) to set as exceptions
to the basic policy selected in the settings.
• If you selected “Reject all specified address(es)
except for those listed below”, enter the IPv4
addresses to allow.
• If you selected “Authorize all address(es) except
for those listed below”, enter the IPv4 addresses
to reject.
Enter an address and click [Add] to add it to the
list.
• To delete an address entered in the list, select
its checkbox, and click [Delete].
• Click the same checkbox to deselect the items.
XXX.XXX.XXX.XXX
format (Where XXX
is a number between
0 and 255.)
IP Address List
(IPv6)
*2
Enter the IPv6 addresses to set as exceptions to
the basic policy.
• If you selected “Reject all specified address(es)
except for those listed below”, enter the IPv6
addresses to allow.
• If you selected “Authorize all address(es) except
for those listed below”, enter the IPv6 addresses
to reject.
Enter an address and click [Add] to add it to the
list.
• To delete an address entered in the list, select
its checkbox, and click [Delete].
• Click the same checkbox to deselect the item.
XXXX:XXXX:XXX
X:XXXX:XXXX:X
XXX:XXXX:XXXX
format (Where XXXX
is a hexadecimal
number.)
*1 If at least one item is registered in the list, you cannot change the basic policy settings.
*2 Depending on the basic policy settings, the address entry item name or the list title
display changes to allow or reject. (For example, if you selected “Allow all specified
address(es)”, the address entry item changes to “Rejected Address” and the list title
changes to “Rejected Address list”.)
Click [Save].
5
The access restrictions are set. •
Press [Back] to cancel specifying the access restrictions and return to the “Secure Settings” •
screen.
Note
Underlined values are the default settings specified at the time of shipment. •
Click [Initialize] to restore the default settings. •
If you become unable to access OfficeBridge after setting access restrictions, perform •
“Delete Restriction Settings” from the control panel of the machine. For details, refer
to Chapter 2, “Specifying the Network Settings” in the Administrator's Guide.