Invacare 1080556 - Manual (Page 24)

Solara™ 24 Part No. 1080556 Rev. I
FRONT RIGGINGS
INSTALLING ADJUSTABLE ANGLE FLIP-UP FOOTPLATE
HINGE (FIGURE 4)
1. Position the adjustable angle flip-up footplate hinge on the footrest support tube at the
desired height.
2. Position the hardware on the footrest support as shown in FIGURE 4.
3. Flip the footplate hinge to the UP position.
NOTE: The footplate hinge will fall to the DOWN position.
4. Tighten the socket screw and locknut that secure the footplate hinge to the footrest
support until the footplate hinge remains in the UP position.
5. Check the up and down motion of the footplate hinge to make sure the user of the
wheelchair can operate the footplates easily.
NOTE: If the footplate's motion is too tight, loosen the socket screw and locknut approximately
1/4-turn.
NOTE: If the footplate's motion is too loose, tighten the socket screw and locknut approximately
1/4-turn.
FIGURE 4 - INSTALLING ADJUSTABLE ANGLE
FLIP-UP FOOTPLATE HINGE
Footrest
Support
Tube
Socket
Screw
Locknut
Footplate
Hinge
FRONT RIGGINGS
FRONT RIGGINGS PROCEDURE 4