Invacare 1080556 - Manual (Page 35)

Part No. 1080556 Rev. I 35 Solara™
ADJUSTING T-ARM WIDTH (FIGURE 11)
1. Remove the two (2) phillips screws that secure the arm pad to the arm tube.
2. Turn the arm pad around and reposition the arm pad on the arm tube.
3. Re-secure the arm pad to the arm tube with the two (2) phillips screws. Tighten securely.
4. Repeat for the opposite side, if necessary.
FIGURE 10 - ADJUSTING T-ARM HEIGHT
Set
Screws
T-Arm Release Lever
- Unlocked Position
Outside T- Arm Post
T-Arm Release Lever
- Locked Position
Inside T-Arm
Post
FIGURE 11 - ADJUSTING T-ARM WIDTH
Phillips Screw
Arm Tube
Phillips Screw
Arm Pad
ADJUSTING THE T-ARMS
ADJUSTING T-ARM HEIGHT (FIGURE 10)
1. Unlock the T-arm by flipping the T-arm release lever towards the inside of the wheelchair.
NOTE: If necessary, pull out on the T-arm release lever and rotate 180° so it can be flipped towards
the outside of the wheelchair.
2. Slide the T-arm to one (1) of:
A. Low Height T-Arms - Nine (9) positions.
B. High Height T-Arms - Seven (7) positions.
NOTE: If the inside T-arm post does not slide up and down in the outside T-arm post as desired,
perform one (1) of the following:
A. Tighten - Tightening the set screws on the outside T-arm post will make it more
difficult to move the inside T-arm post up and down.
B. Loosen - Loosening the set screws on the outside T-arm post will make it easier
to move the inside T-arm post up and down.
3. Lock the T-arm by flipping the T-arm release lever towards the front of the wheelchair.
ARMS
PROCEDURE 5 ARMS
ARMS