Invacare 1080556 - Manual (Page 48)

Solara™ 48 Part No. 1080556 Rev. I
ADJUSTING LOWER TILT LOCKING COLLAR (FIGURE 4)
NOTE: This procedure limits the amount of tilt the wheelchair may have. If adjusting the angle the wheelchair
returns to, refer to ADJUSTING UPPER TILT LOCKING COLLAR in this procedure of the manual.
1. Loosen the two (2) socket screws that secure the tilt locking collar to the tilt slide.
2. Repeat STEP 1 for opposite side of wheelchair.
NOTE: To determine tilt angle relative to the seat frame, place a magnetic protractor (available at any
hardware store) on the back and adjust the back until the magnetic protractor reads desired angle of tilt.
3. Tilt the wheelchair to the desired angle of tilt.
4. Position the two (2) tilt locking collars against the bearing housing.
NOTE: Before tightening, ensure that the two (2) tilt locking collars are at the same position on the tilt slide.
5. Securely tighten the four (4) socket screws of the tilt locking collars.
Socket Screws
Lower Tilt
Locking Collar
Tilt Slide
Bearing Housing
FIGURE 4 - ADJUSTING LOWER TILT LOCKING COLLAR
TILT-IN-SPACE
TILT-IN-SPACE
TILT-IN-SPACE PROCEDURE 7