Invacare 1080556 - Manual (Page 41)

Part No. 1080556 Rev. I 41 Solara™
BACK/SEAT
ADJUSTING (FIGURE 4)
1. Flip both release levers to the unlocked position.
2. Adjust stroller handle to desired angle.
3. Flip both release levers to the locked position.
4. Push down on stroller handle to ensure release levers hold the desired position of the
stroller handle.
5. If release levers do not hold the position, tighten the release lever by performing the
following:
A. Flip release lever to the unlocked position.
B. Rotate thumbscrew CLOCKWISE one (1) revolution.
NOTE: When tightening the release lever, the release lever must be able to close completely into the
locked position. Otherwise, the release levers will not hold the desired angle.
C. Flip release levers to the locked position.
NOTE: If the release levers do not close completely into the locked position, rotate the thumb-
screw on each release lever COUNTERCLOCKWISE 1/2 revolution.
D. Repeat STEPS A-C for opposite release lever.
E. Push down on stroller handle to ensure release levers hold the desired position of
the stroller handle.
F. Repeat STEPS A-E until release levers hold the position.
FIGURE 4 - ADJUSTING THE ADJUSTABLE ANGLE STROLLER HANDLES
Stroller Handle
Release
Lever
LOCKED
POSITION
Thumbscrew
BACK/SEAT
PROCEDURE 6 BACK/SEAT