Invacare 1080556 - Manual (Page 43)

Part No. 1080556 Rev. I 43 Solara™
INSTALLING/REPLACING THE BACK UPHOLSTERY
(FIGURE 7)
INSTALLING
1. Position the back upholstery on the back
cane as shown in FIGURE 7.
2. Starting with the top two (2) mounting
holes secure the back upholstery to the
back canes with the ten (10) phillips
screws and washers.
REPLACING
1. Remove the ten (10) phillips screws and
washers that secure the back upholstery
to the back canes.
2. Remove existing back upholstery from
back canes.
3. Install new back upholstery onto the back
canes.
4. Install the ten (10) phillips screws and washers that secure the back upholstery to the back
canes.
INSTALLING/REPLACING CHEST POSITIONING STRAPS
(FIGURE 6)
INSTALLING
1. Position the chest positioning strap to one
(1) of the holes on the back cane.
NOTE: The standard recommended position for the chest
positioning strap is in the top hole of the back cane, but
may be mounted according to the user's needs.
2. Secure the chest positioning strap to the
back canes with the NEW/EXISTING hex
screw and locknut as shown in FIGURE 9.
3. Repeat STEPS 1-2 for opposite side.
REPLACING
1. Remove the hex screw that secures the chest positioning strap to the back cane.
2. Discard EXISTING chest positioning strap.
3. Repeat STEPS 1-2 for opposite side, if necessary.
4. Install the NEW chest positioning strap. Refer to INSTALLING CHEST POSITIONING
STRAPS in this procedure of the manual.
Hex Screw
Chest Positioning Strap
Back Cane
Locknut
FIGURE 6 - INSTALLING/ REPLACING
CHEST POSITIONING STRAP
FIGURE 7 - INSTALLING/
REPLACING THE BACK
UPHOLSTERY
Back
Cane
Back
Upholstery
Phillips
Screw
Washer
BACK/SEAT
BACK/SEAT
PROCEDURE 6 BACK/SEAT