IBM SG24-4576-00 - Manual (Page 140)

21. Type DOWN at the colon prompt.
22. Type EXIT at the colon prompt to return to DOS and finish the installation.
23. Reboot the server and verify that the server comes up properly.
The installation is complete. You are now ready to log on as the administrator
and add users and applications.
4.4 Installing NetWare 3.12 with Diskettes
In this section, we detail the procedures necessary to install NetWare V3.12 via
the original product diskettes.
4.4.1 Hardware Requirements
The following hardware is required to install NetWare 3.12:
• One file server with an Intel 386 processor or higher
• A minimum of 6 MB of RAM
• A minimum of 10 MB in the DOS partition
• At least one network adapter card for the server
4.4.2 Software Requirements
The following software is required to install NetWare 3.12:
• NetWare 3.12 diskettes
• DOS 3.3 or later
• Drivers for disk controller and LAN adapter cards
4.4.3 Information Requested at Time of Installation
When you are installing NetWare 3.12, you will have to provide the following
information:
• Server name
• IPX internal network number
• Locale information including country code, code page, and keyboard
mapping
• Filename format
• Disk type
• I/O port address and interrupt setting of hard disk controller
• LAN drive type
• I/O port address and interrupt value of network board
4.4.4 Installation Files
The NetWare 3.12 installation uses the following files:
1. INSTALL.BAT
INSTALL.BAT is a utility that is used to automate the installation of the
server boot files.
2. SERVER.EXE
Chapter 4. Novell NetWare Installation
127