IBM SG24-4576-00 - Manual (Page 83)

3.1.2.1 Advanced Menu - Boot Options
By pressing the Enter key, a screen like that shown in Figure 25 will appear.
Phoenix BIOS Setup - Copyright 1985-94 Phoenix Technologies Ltd.
────────────────────────────────────────────────┬──────────────────────────
Advanced │
────────────────────────────────────────────────┼──────────────────────────
Boot Options │
────────────────────────────────────────────────┼──────────────────────────
│
Boot Sequence: [A: then C:] │
Swap Floppies: [Normal] │
Floppy Check: [Enabled] │
│
SETUP prompt: [Enabled] │
POST errors: [Enabled] │
│
│
│
│
│
│
│
│
│
│
│
Figure 25. PC Server 320 Setup Program - Boot Options M e n u
Boot Sequence: Boot sequence allows the user to change the order the system
uses to search for a boot device.
Other values can be:
• C: then A:, if the user wants to boot from the hard disk first
• C: only, if the user does not allow a boot from a diskette
Swap Floppies: This choice allows the floppy disk drives to be redirected.
Normal is the default. When Swapped is selected, drive A becomes drive B and
drive B becomes drive A.
Note
The option Swapped does not modify the boot sequence option. So if boot
sequence is set to A: then C: and Swap floppies to Swapped, the user will get
the following error message at IPL:
0632 Diskette Drive Error
Floppy Check: When enabled, the floppy drives are queried at boot time to
verify the correct drive type. The machine boots faster when disabled.
Setup prompt: When enabled, the following message appears:
Press <F2> to enter SETUP
If disabled, the prompt message is not displayed but the function is still
available.
POST errors: When enabled, if an error occurs during power on self-tests
(POST) the system pauses and displays the following:
Press <F1> to continue or <F2> to enter SETUP
Chapter 3. H a r d w a r e Configuration
69