Sharp AM-900 - Manual (Page 55)

Making a Copy
53
2. Cop
y
ing
x Contrast: Medium (bar at mid-point)
(Note: The default contrast setting can be changed as explained on page
59.)
x E-Sort (collating sets of copies): OFF
x Duplex Scan: OFF
Note: After temporary copy settings are selected, the settings will revert to the
above default settings if the auto clear time elapses without any keys being
pressed on the operation panel (see page 48). You can also press to
reset the settings to the default settings.
4
When you are ready to make the copy, press .
x If Duplex Scan is selected:
After the stack of originals is fed through the auto document feeder, turn the
entire stack over (do not change the order of the pages or remove any
pages), insert it into the auto document feeder again, and press .
x If you are using the document glass to copy multiple originals and E-
Sort is selected:
After the original is scanned, the following alternating messages will
appear:
Remove the original from the document glass, place the next original, and
press . Repeat until all originals have been scanned. After the last
original has been scanned, press to begin printing the copies.
[START] NEXT SCAN [#] START PRINT
Maximum original size when using the document glass
The maximum original size that can be used on the document glass is letter
or A4 (8.5
u 11.7 inches). The maximum scanning width is 8.2” (208 mm),
and the top and bottom 0.16” ( 4 mm) of the original cannot be scanned.