Sharp AM-900 - Manual (Page 70)

Sending a Fax
68
5
Check the display. If the name or number shown is correct, press .
x If you made a mistake when entering a number, press to backspace
and clear one digit at a time, and then re-enter the correct digit(s).
6
Scanning of the original(s) will begin.
x If you are using the auto document feeder:
After the originals are scanned, the machine will dial the receiving machine
and send the fax. If the machine is busy with a previously stored job, the fax
job will be stored in memory and then transmitted once the machine is free.
x If Duplex Scan is selected: After the stack of originals is fed through the
auto document feeder, turn the entire stack over (do not change the order of
the pages or remove any pages), insert it into the auto document feeder
again, and press . After scanning is finished, the machine will dial the
receiving machine and send the fax. If the machine is busy with a
previously stored job, the fax job will be stored in memory and then
transmitted once the machine is free.
x If you are using the document glass:
After the original is scanned, the following alternating messages will
appear:
Remove the original from the document glass, place the next original, and
press . Repeat until all originals have been scanned. After the last
original has been scanned, press to end scanning. The machine will
dial the receiving machine and send the fax. If the machine is busy with a
previously stored job, the fax job will be stored in memory and then
transmitted once the machine is free.
Note: If no keys are pressed for one minute after the original is scanned,
fax transmission will begin automatically (or the job will be stored).
START: CONT. READ # KEY: END OF SET
x If the transmission is completed successfully, the machine will beep once.
x If an error occurs, the machine will beep three times and print a
Transaction Report to inform you of the problem (see page 128).