SOYO SY-5S - Manual (Page 105)

SiS VGA Driver Installation SY-5STM
101
Install SiS 5597/5598 OS/2 Warp drivers according to the following
procedures:
1st phase:
1. Enter “OS/2 window” or “ OS/2 full screen.”
2. Change directory to which holds the SiS 5597/5598 OS/2 3.0
display drivers and type SETUP <Enter>. For example,
D:\>SOYO_CD\REV_10\UTILITY\SIS_VGA\OS2\DBCS30\SET
UP.
3. All the Driver Files will be copied to a sub-directory C:\SISDRV
and an “ SiS Install” icon will be created.
4. After completing “ setup” program, shutdown and re-boot OS/2.
2nd phase:
5. After re-booting OS/2, double clicks “SiS Install” icon. The “ SiS
Install” icon would be executed automatically and “ Select
Screen parameters for SiS SVGA” screen will appeared on the
screen.
6. Select the desired resolution (and color) and frame rate on this
screen, then click “ OK” to complete installation. The “ SiS Setup”
icon will be created for future change modes and frame rate
usage.
7. After completing installation, shutdown and re-boot OS/2 to
make your selection effective.