SOYO SY-5S - Manual (Page 29)

Quick Installation Guide SY-5STM
25
Please install the ATX power according to the following pin
assignment:
Ø Pay special care to the directionality.
Ø Make sure pin 1 is in its position.
Step 13. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
Step 14. Power On
You have now completed the hardware installation of your
mainboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
Repeat this operation until you get the following screen.
ATX Power
12V
5VSB
PW-0K
GND
5V
GND
5V
GND
3.3V
3.3V
5V
5V
-5V
GND
GND
GND
PS-ON
GND
-12V
3.3V