SOYO SY-5S - Manual (Page 92)

SiS VGA Driver Installation SY-5STM
88
6-3.4 AutoShade R2.0 Setup
1. The following procedures assume that
Ø You have completed the “unpack & copy” procedure.
Ø Your ADI 4.2 drivers are located in C:\ADI42.
2. Add the following settings to your own batch file for AutoShade
R2.0 (i.e. SHADE2.BAT) or to your AUTOEXEC.BAT file.
Ø For display driver settings:
SET DSPADI=\ADI42\RCPSIS.EXP
Ø For rendering driver settings:
SET RDPADI=\ADI42\RCPSIS.EXP
3. Delete the configuration file SHADE.CFG.
4. Type SHADE2 <Enter> to re-configure the AutoShade.
5. While prompting “Select display device” choose “P386
AutoDesk Device Interface display driver” .
6. While prompting “Select rendering display driver.” Choose
“P386 AutoDesk Device Interface rendering driver” .
7. Perform all the listed instructions and the system will start with
the desired display settings.
6-3.5 3D Studio Version 3.0 Setup
1. The following procedures assume that
Ø You have completed the “unpack & copy” procedure.
Ø Your ADI 4.2 drivers are located in C:\ADI42.
2. Create your own 3D Studio V3.0 batch file (say 3DS3.BAT)
and add the following settings to it, or add the following settings
to your “AUTOEXEC.BAT” file:
Ø SET RCPADE=C:\ADI42\RCPSIS.EXP
Ø SET RDPADI=C:\ADI42\RCPSIS.EXP
3. Execute the new 3DS batch file or reboot the computer using
the new “ AUTOEXEC.BAT” to make the new settings effective.