SOYO SY-5S - Manual (Page 83)

ALS120 Audio Driver Installation SY-5STM
79
5-4 Windows NT 3.5/4.0
1. Ensure that ALS120 is installed properly and power on the
system.
2. Insert the ‘ CD Title Disk’ into drive D (CD-ROM). Go to [Control
Panel/Multimedia/Device/Add] and choose [OK] for ‘ Avance
Logic, Inc. Sound Chip’ .
3. While installing, “ Driver Exists" warning message will appear
and ask whether to keep the old ‘ midimap.cfg’ or [re-install].
Please select [re-install], otherwise MIDI will not function
properly.
4. Configure the proper I/O’ s and DMA’ s if necessary as they
appear on screen.
5-5 Setup Utility Program
A3CONFIG.EXE
This utility program is used to set up the ALS120 sound card. It is
automatically started when the Avance Logic software drivers are
first installed in a DOS or Windows 3.1 application. It should be re-
run anytime the system hardware configuration is changed or a
change to the ALS120 sound card configuration is desired. The
A3CONFIG.EXE utility resides in the directory into which the Avance
Logic software drivers were stored.
Configuration
To run the A3CONFIG.EXE, perform the following:
1. If Windows 3.1 is running, exit the application and at the C:\>
prompt, set the current directory to the directory containing the
A3CONFIG.EXE utility (A3SOUND was the default directory at
the time of installation), type A3CONFIG.EXE, and then press
the <Enter> key to execute the utility.