SATO GT424 - Manual (Page 10)

Section 1: Introduction
Page 1-4 GT Series Operator’s Manual
1.1 GENERAL SPECIFICATIONS (CONT’D)
Specification/
Model Name
GT408 GT412 GT424
Print method Thermal transfer or thermal
Head density 8 dots/ mm (203 dpi) 12 dots/ mm (305 dpi) 24 dots/ mm (609 dpi)
Print valid range (width) 104 mm x pitch 2500 mm 104 mm x pitch 1500 mm 104 mm x pitch 400 mm
Not printable for 3 mm from the backside.
Print speed (Max) 12 inches/sec
(Approx 300 mm/sec) 12 inches/sec
(Approx 300 mm/sec)
6 inches/sec
(Approx 150 mm/sec)
Note:
Maximum speed may be further dependent on the type of print layout, paper,
or carbon ribbon in use.
Paper Thickness 0.060 mm to 0.268 mm supported.
Note:
Be sure to use only printer supplies manufactured or certified by SATO.
Label size
(mounting
and
cardboard
size)
Standard Width: 22 to 128 mm (25 to 131 mm)
Pitch: 5 to 397 mm (9 to 400 mm) Note:
Supported sizes may be
regulated due to the quan-
tity of print jobs or size of
paper.
Other usage conditions
may restrict the range of
label sizes supported.
Tear off Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Peel Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Cutter Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Non-sepa-
rate Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Number of
loadable
sheets Roll paper Maximum external diameter:
200 mm (Approximately 150 m/roll) 3-inch paper tube used
Back winding (only front winding for non-separate mode)
Fanfold
paper Maximum folded height: 200 mm
See the section in this manual on Setting Fanfold Paper
Carbon ribbon
Width
Length
Thickness of base material
Color
Winding direction Be sure to use the specified carbon ribbon manufactured by SATO.
39.5, 45, 59, 76, 84, 92, 102, 111, and 128 mm
Use a carbon ribbon that is wider than the paper used.
300 m/roll
4.5 µm
Black (standard), also red, blue, purple, and green
Front winding and back winding
Label dispensing modes Continuous, tear off, peeler, dispenser and non-separate
Dimensions W 271 mm x D 455 mm x H 305 mm x (Standard)
Weight 14 kg (for a standard configuration)
Power supply Input voltage: AC 100 V to 240 V ±10%
Power consumption: Maximum 200 VA 150 W, print rate 30% (89 VA 40 W on standby)
Operating Environment Operational ambient temperature: 0 to 40 ×C
Operational ambient humidity: 30 to 80% (without condensation)
Storing ambient temperature: - 5 to 60 ×C
Storing ambient humidity: 30 to 90% (no condensation)
Paper, and carbon ribbon excluded.