SATO GT424 - Manual (Page 142)

Section 6: Troubleshooting
Page 6-8 GT Series Operator’s Manual
17
BCC Check error
Cause:
Remedy:
Alarm sound:
External signal:
BCC attached to sending data (for an item) is different
Check the settings controlling data communication
Three short beeps
Machine error
18
Item Number error
Cause:
Remedy:
Alarm sound:
External signal:
The sequence number of print data (for an item) does not
match the sequence number of the previously printed
data
Check the settings controlling data communication
Three short beeps
Machine error
19
Winding Full error
Cause(s):
Remedy:
Alarm sound:
External signal:
1. The label rewinder needs to be emptied
2. The sensor is malfunctioning
Remove the wound label. If the same error message per-
sists, contact a sales outlet, dealer, or service center
Three short beeps
Machine error
20
Head Density error
Cause(s):
Remedy:
Alarm sound:
External signal:
1. The print head has not been mounted properly in the
printer
2. An unsupported print head has been mounted
Check that the print head is suitable for use with this
printer, and that the print head is mounted properly
Three short beeps
No output
21 Kanji ROM error
Cause:
Remedy:
Alarm sound:
External signal:
Invalid Kanji data has been read from the Kanji ROM
Make sure the Kanji ROM has been properly mounted. If
the same error message persists, contact a sales outlet,
dealer, or service center
Three short beeps
Machine error
Error No. LCD Message Description