SATO GT424 - Manual (Page 62)

Section 3: Configuration and Operation
Page 3-26 GT Series Operator’s Manual
3.11.2 Setting Test Print Width for Configuration, Barcode
and Head Check
If you chose test prints of Configuration, Barcode and Head Check
in the previous menu, this screen lets you choose the width of the
test print from “04” to “10” cm, in increments of 1 cm,
Press the buttons to choose the print size. Press the
ENTER button to confirm the setting and proceed to the next
screen.
3.11.3 Setting the Size of the Factory Test Print
For Factory test prints, this screen appears instead of the previous
screen for setting print size. In this screen, you can choose only to
print the test results in LARGE or SMALL print widths. The LARGE
setting results in a 10 cm print width. The SMALL setting results in a
4 cm print width.
Caution
If you are using narrow labels, do NOT set this option to LARGE; otherwise, this may damage the print head.
Press the buttons to choose LARGE or SMALL. Press the ENTER button to confirm the
setting and proceed to the next screen.
3.11.4 Starting the Test Print
When you are ready to print out the test data, press the ENTER
button. The test print will start, and it will cycle continuously.
During printing, the ENTER button can be used to suspend and
resume the test printing.
To exit the Test Print mode, turn of the printer.