SATO GT424 - Manual (Page 35)

Section 2: Installation
GT Series Operator’s Manual Page 2-23
2.5 TURNING THE PRINTER ON/OFF
1. After removing the cable cover at the rear of the printer
(See Page 2-7), you can proceed to install the interface and
power cables as shown.
2. To limit movement of the cables, you can optionally channel
the cables through the cable hook area at the base of the
printer.
3. Insert the power cable first to the printer, then connect the
other end to the power outlet. If necessary, use an adapter to
match the prongs on the power cable to the sockets in the
AC outlet.
Caution
• Always use a grounded power cable to protect against electrical leakage and
electrical shocks.
4. To turn the printer ON, press the power switch to the “I” side.
When the printer is successfully turned on, the LCD screen
will display something similar to that shown here.
Caution
• To prevent electric shocks, make sure your hands are dry when you operate the
power switch, or when you pull out or insert power cables and switches.
5. If the printer does not respond, refer to the Troubleshooting
section of this manual.
6. Before turning the printer off, perform the following steps:
Take the printer offline by pressing the Line button. The LCD
shows the following:
• Press the Feed button to eject any label at the front of the
printer.
• Lightly pull the paper diagonally downward to tear off the
label.
7. To turn the printer off, press the power switch to the “O” side.