SATO GT424 - Manual (Page 133)

Section 5: Interface Specifications
GT Series Operator’s Manual Page 5-51
5.24 DRIVER PROTOCOL (CONT’D)
c) Status Byte Definition (Continued)
(2) System Version Data Request
In receiving this command, the printer system version information is echoed.
a) Command SOH (01H) + SB
b) Responded Status Definition
STX + Printer System Version + ETX
c) Status Byte Definition
No. Item Contents Byte no.
10 Zero Slash 00H: Inactive
01H: Active
1
11 Reserved 1
12 Reserved 1
13 Reserved 1
14 Character Gap 00H: Fixed pitch
01H: Proportional pitch
1
15 Vertical label size Maximum vertical label size may change
depending on the printer. 2
16 Horizontal label size Maximum horizontal label size may
change depending on the printer. 2
17 Vertical base reference
point offset 00H – 3C0H (0 – 960 dots) 2
18 Horizontal base
reference point offset
00H – 3C0H (0 – 960 dots) 2
19 Reserved 1
20 Reserved 1
21 Reserved 1
22 Reserved 1
23 Reserved 1
24 Reserved 1
25 Buzzer settings 00H : Enabled
01H : Disabled
1
No. Item Contents Byte number
1 Operating system ASCII code 10
2 Printer firmware ASCII code 10
3 Interface ASCII code 10
4 Font ASCII code 10
5 Font download ASCII code 10